7.10.9 – 12 Rivet flaps

All the parts for the flaps have been primed and left to cure for a few days so today is a good day to rivet the flaps together. It’s always a fun but nerve racking time because so much effort has been spent so far and one small mistake could mean a big do over.

I started with the bottom skins and riveted the 4 inner ribs to the end of the bottom skin and then to the rest of the bottom skin.

Next I riveted the reinforcement plate to the end rib.

Then riveted the inboard end ribs to the bottom skins but left the outboard just clecod for now as they can be reached with the squeezer.

Once that was done I made a couple of V blocks as per the instructions and then put the top skin on and sat the assembly in the v-blocks.

Once it was in the v-block I was able to rivet all the top skin rivets with the tungsten bucking bar and rivet gun. There are a couple of rivets at the very lowest point that must be pop-riveted because of their location but the rest were do-able. Once that was done I riveted on the rear spar using blind rivets as per the plans. I had quite a bit of trouble with the rivets near the reinforcement plate as the holes were too close to the bend and so the rivet puller simply wouldn’t fit. In the end I worked out that a single eye from a piano hinge was the perfect left the raise the rivet puller high enough to do the job. Unfortunately with all that head scratching I forgot to take any pictures until both rear spars had been fitted.

The last job was to rivet on the piano hinge. To do this I needed to change the yoke. There are two pins with ring pulls that hold the yoke in place and today, for some reason, I forgot to put both pins in. As I started riveting there was an almighty crack and the rivet squeezer was toast! The picture below shows the broke part either side of the spring. That part is supposed to be one piece. 🙁

Luckily I still had my pneumatic squeezer so I was able to get the piano hinges finished.

The flaps look good but I’m not 100% happy with the left flap where I had to drill out a blind rivet as it has left a bit of a mess. I will check with my inspector and see if he is happy with it as it is or if he has any ideas on fixing it. A long, but productive, day today.

Leave a Reply

Your email address will not be published. Required fields are marked *

%d bloggers like this: